Original: $69.99
-70%$69.99
$21.00The Story
Chevrolet Camaro 3.6/6.2 O2 Sensor Extensions 12 Inch 10-15
PART #1115
FEATURES:
- For Use With Full Length Headers
- 12" Length
- Direct Plug In
- Sold in Pairs
- 2008-2015 Camaro & Corvette 3.6/6.2 Applications
Complete Your Header Installation
Properly relocate the oxygen sensors on your 2008-2015 Camaro / Corvette 6.2 with these BBK Performance 12" O2 sensor wire harness extensions. These BBK Performance oxygen sensor extensions are an absolute must when installing full length headers due to the oxygen sensor being relocated further down the headers.
Easy Installation
BBK Performance oxygen sensor extensions feature OEM Factory connectors on the end of the wiring to allow simple plug in installation to the factory wire harness. The extension wires are covered with a heat protective sleeve for maximum protection.
Locator Tabs
These O2 sensor extensions will work on 3 and 4 wire applications. Some connectors may require the small directional location tabs to be removed on the ends of the connectors to click into place. No cutting or splicing is required.
Description
Chevrolet Camaro 3.6/6.2 O2 Sensor Extensions 12 Inch 10-15
PART #1115
FEATURES:
- For Use With Full Length Headers
- 12" Length
- Direct Plug In
- Sold in Pairs
- 2008-2015 Camaro & Corvette 3.6/6.2 Applications
Complete Your Header Installation
Properly relocate the oxygen sensors on your 2008-2015 Camaro / Corvette 6.2 with these BBK Performance 12" O2 sensor wire harness extensions. These BBK Performance oxygen sensor extensions are an absolute must when installing full length headers due to the oxygen sensor being relocated further down the headers.
Easy Installation
BBK Performance oxygen sensor extensions feature OEM Factory connectors on the end of the wiring to allow simple plug in installation to the factory wire harness. The extension wires are covered with a heat protective sleeve for maximum protection.
Locator Tabs
These O2 sensor extensions will work on 3 and 4 wire applications. Some connectors may require the small directional location tabs to be removed on the ends of the connectors to click into place. No cutting or splicing is required.
